How do i hook up a remote starter
To test the power wires using the multimeter attach it to the wire when the car is off and the key is out of the ignition. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts.
You can always try the fuse work around but be aware it could all go wrong on you.
And how do I fix it? My Suabaru had a flat battery in the night because the door.
Anybody can ask a question Anybody can answer The best answers are voted up and rise to the top. If a vehicle manufacturer does something odd, the starter manufacturer likely can't account for that. Plug the ground cable into the starter kit. Thank you so much. Become familiar with the wires in your vehicle by looking over the manual and repair guides.
This keeps them from falling apart and potentially damaging your vehicle. Thank you very much. Secure the box however you would like, making sure that all cables will be out of the way of the panels that you have to install back on.
Richmond, TX 9 dollars, 2 hours of my time, and I drove away. TDHofstetter 2, 5 The voltage should be zero when the key is in all positions except while cranking the engine.
Remote Car Starter Installation Done Right
A relay allows multiple wires to be connected together. Replace the kick panel and the panel covering the ignition switch.
To find the brake wire press the brake pedal down while the car is on and use the multimeter to test the wire. These are the airbag wires and must not be tampered with or unplugged. However, I don't know where the wires goes that comes off the ignition coil and starts to go towards the back of the engine and down.
Brucee_Seldon - 05.08.2017 in 20:07
Use a soldering iron to connect all wires. This comes in handy when you might want to perform a compression test on the car.
zerO_klone - 14.08.2017 in 21:25
Car Electronics In other languages: Part 1 of 5: