Garbage disposal drain hook up
Clean up any excess putty. If permanently wired to a circuit, turn off the disposal unit at the breaker panel.
Push the wires back in and reattach the plate. Thanks for helping us achieve our mission of helping everyone learn how to do anything. This time I'll leave it just hand tight just a little bit loose for now and we'll comeback and snug it up in a minute.
Get Pricing & Availability
I am going to shove that all the way in and I am going to take the piece of flex hose fitting, put that on there and tighten it up. Locate the flange gasket. Connect the black wire from the cable to the black wire from the disposal with a wire nut. Clean the Sink Clean the sink well, especially around the drain opening. And when connecting up P-traps, you need to make sure that all the parts can reach each other.
To connect to the dishwasher drain, use a hammer to knock out and remove the drain plug from the inlet on the disposal.
Batch feed disposals, which are a bit more expensive, require the use of a stopper prior to operation, which can be safer in households with kids. Consider the features you want the disposal to have. Use a knife to trim it away.
Remove Breakout Plate Step 9: Install the Disposal Instructions Step 1. Check to see if you need a permit.
Looney_Decoy - 06.09.2017 in 20:07
Then we are going to put our P-trap on right here.
Ezio_Auditore - 12.09.2017 in 20:35
Whenever you cut off a PVC pipe, you need to make sure you're leaving about an inch for gluing a new fitting on.
Aleksandr_Prodoza - 18.09.2017 in 12:00
What that does is that water pushes out against that plate, the flange plate, gives you a nice water tight seal. Did this article help you?
James_Caprone - 27.09.2017 in 01:36